Feedback panels are a part of our Smart Cleaning solution, giving you the ability to receive feedback from multiple touch sensors with each sensor signalling a different message or purpose.
Step by Step Guide
On the platform navigate to the cogwheel at the bottom left hand corner of the page.
You will see an option to 'Install sensors,' click on 'start install'
A pop up will appear asking you to identify the device. You will need to select 'Manually Identify Device,' this will bring up a list of devices to choose from.
Scroll until you see 'Feedback Panels' and select device.
Now you will be asked to 'Choose a feedback panel template.' There is currently only one option to choose from so you will click on select.
You will now see 'Good Fair Poor panel setup.' This is where you will set up your 3 touch sensors for your feedback panel.
Click on 'Identify Sensor' for 'Good.' You will be prompted to press and hold down the touch sensor for 3 seconds. You will be asked to touch it again to confirm.
Once confirmed there will be a small green pop up on the side of the screen as well as the sensor ID now showing that it is connected.
Repeat the process for the remaining two sensors.
Once all your sensors are identified, peel off the brown paper on the back of the sensors to reveal the sticky side. Now place each sensor in the relevant area on the feedback panel.
Note: For best results, always start with a clean and dry surface. If required, clean the surface as by 3M in this application note.
Once you have completed that proceed to configure the device and enter the details for where the feedback panels will be located, ie. building, floor, room, etc. and then name your feedback panel.
Now you can click save and the feedback panel will be configured and you can proceed to physically install them where you have said they would be located.
Make sure to map the location of the sensors on the floor plan.
If you need to do another feedback panel, you can click 'Setup another panel' or you can click finish.